©2019 by Pico MES

Bit Tray Basics Quick Start Guide

1. What's in the Box

Wire Harness
(Custom or Controller Specific)
Wireless Bit Tray
Screwdriver & Accessories
USB-C Charging Cable
Controller Interface Module
 

2. Overview

The wireless bit tray system enables all of the benefits of a traditional bit tray, without the cords that limit its mobility.  A digital input and output module (DIO) is connected to the controller's 24V accessory terminals, maintaining wireless communication to the bit tray.  

The bit tray uses a rechargeable 3.1Ahr li Ion battery, with a USB-C charge port, operating for multiple shifts on a single charge.  LEDs are used to indicate not only the commanded bit (socket select mode), but also the status of each bit presence sensor, eliminating any issues if debris blocks the bit from fully seating. 

Accessory kits are included to enable an easy installation to standard controllers.

 

Lower row of 8 - Blue

  • Bit Presence indicator

  • Will be blue if a bit is sensed.

Power Indication - Red when on

Upper row of 8 - Green

  • Triggered by the outputs

      of the controller

  •  #1 is the left. #8 is far right.

3. LED Indicators - DIO

Communication Status

  • Blue = on & not connected to bit tray

  • Green = on & connected to bit tray

  • Red = Lost connection with bit tray

LED Indicators - Bit Tray

1
2
3
4

Green

Bit Commanded

Indication

(when used with

Socket Select)

Communication Status

  • Blue = on, not connected to DIO

  • Green = on & connected to DIO

  • Yellow flashing = low battery 

  • Red = lost connection 

Charging Status

  • Blue = fully charged

  • Green = charging

Charge Status

  • All 4 Green = fully charged

Blue

On when bit

is present

5
6
7
8
 

Communication LEDs should always match each other. 

Bit commanded and present indicators should always match each other.  If the torque tool has an error code, these indicators make it easy to understand if the issue is with the controller, or with the bit tray system.

4. Bit Tray System LEDs

Status LEDs should always match

 

5. How To Charge

Any USB charger can be used with the supplied cable to charge the bit tray.  

The Ingersoll Rand QX battery charger is equipped with a USB output that can be used to charge the bit tray 

USB-C to bit tray can be installed in either orientation